Spindle Belt

[redcraftmodels]

Hello. I have a question about a spindle belt for a 9 in logan lathe ser. no 2164A, and where to obtain a belt that you do not have to remove the spindle. I have not had any luck finding any other info about the machine. Thank you.

[LoganAct]

If that serial number is correct, this is not a 9". It is a Montgomery Wards 10" lathe, built by Logan Engineering Co. in 1947.

It should use a 39" flat belt, which can be ordered here:

http://store.lathe.com/lp-1183-1.html

You might also consider ordering the manual, which is available here:

http://store.lathe.com/pl-04.html

Scott Logan
Logan Actuator Co.
http://www.lathe.com

[redcraftmodels]

Hello. Scott Logan. Thank you very much for your info. checked ser. again it is just as listed it. great to know that a manual is available, budget will have to be worked out. The belt will be first. Thank you.